by Geoffro, published
This print is intended for personal or charity use. There is not a lot I can do about procoprick3D selling it on his website, or the 'simmsfamilyemporium' or' just3dprints' selling it on Ebay, but why should those scruffy nerf-herders ruin it for everyone else? All I can do is hope people download and print if for free rather than give them $100-$300 for a poor quality print - and besides, isn't half the fun building it yourself?? If you are going to just buy one outright - you can buy screen accurate ones for much less than these bozo's charge for a printed one!
You are VERY welcome to sell one you have made - please understand. It's the setting up shop to mass produce them that is really not cool, and especially if you don't provide any credit or links back here.
No, if you want to sell a helmet you have made, go for it. No need to send me a message, if you are selling a finished Helmet, then hey - good luck to you and I hope you make a few bucks off it. After the hard work you put in to making one, if you really want to part with it for money, then that's your choice, but just no "Justprint3D" mega rip off ebay stores ok? cool.
/rant over..
Update 17/2/2016
thanks Maso27 for the input, he was right - the section above the ear needs to be more square instead of rounded like the Storm Trooper helmet. You can do this yourself with some putty when finishing if you've already made or started making it - but I will update the files for those who haven't. It's a minor detail but if you are trying to get screen-accurate, it's important :p
Update 16/2/2016
Full Helmet uploaded in one piece. Watermark added.
Well, as little time as Captain had on screen, it was a pretty cool outfit.
It took a while to get even close to being happy with the detailing on it... but even now I think it needs more, but at least what I learned from this I can go back and apply to the storm trooper helmet, most notably the cheek texturing.
Sizing and assembly Part numbers are in the images.
Pieces are cut to fit on a Replicator 2 or above print area.
No parts are over 20cm wide, no deeper than 14cm and no parts are over 14cm tall.
20 Parts, only 18 necessary. Parts 5 and 6 are optional visor inserts for display helmets.
The sizing on this should fit most heads, I scaled it to be just slightly bigger than the Ep7 first order helmet.
Happy printing and as always, may the force be with you.
No derivatives are to avoid others uploading copies and those being sold without disclaimer.
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2 to 0.3
Infill: 5% to 10%
Notes:
I would use 2 shells myself at 0.2 or 0.3mm. Nearly all the parts will print without support - with exception parts 3 & 4 Parts 3 and 4: Don't flip them upsidown, I plated them the way they are will use very very little support. If you flip them, it will increase the print time by a couple hours and make a tonne of support - trust me.
