A cellular sculpture I designed. I used it as a candle holder, but when printed properly it can also be used as vase for flowers. To make sure the thing isn't melted by the candle I used a small, but high glass as container for the candle. The one I used has a diameter of 55 mm and is about 110 mm in height. I suggest you find a glass container first and adjust the model's dimensions accordingly.
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
No
Resolution:
50 micron
Infill:
100%
Notes:
The model is not too hard to print, although it is important to keep the speed of the printer fairly low. Most of this print was done at a speed of 60 mm/min. When the bottom part is used to store water I suggest to print the model with an 100% infill to avoid leaks.
