| Description:Product specification:- Print temperature: 190-225°C- Raft temperature: 190°C- First layer temperature: 225°C- Filament diameter: 1.75mm- Filament diameter variation: less than +/-0.1mm- 1kg each roll ( apart from 10 colour rainbow pack 50g/colour)- Supplied on reel so can be used straight away ( apart from rainbow pack) 1KG Filament Choose from: Black;White;Blue;Red;Pink;Green;Gold;Silver;Yellow;Orange;Grey;Natural;Purple;Transparent Rainbow Pack Contains 10 colour 50g/colour : Black;White;Blue;Red;Green;Yellow;Orange;Grey;Natural;Purple Note:1.75mm filaments suit for all the 3D printers as follows:Makerbot printer, UP printer, Afinia printer, Solidoodle printer, Delta printer, Huxley printer, leapfrog3.0mm filaments suit for all the 3D printers as follows:Mendel, mendel max, Ultimaker Q&As?1. What is your filament diameter specification?For 1.75mm filament, the specification is 1.68mm~1.78mm, normally between 1.7~1.73mm.2. What is your idea printing temperature?It is hard to get a fixed printing temperature.In fact it is determined by material itself and printer sensor.If the printer sensor is not good, which will mislead the printing job.As to material itself, the ABS can be printed between 200C to 260C and the idea is 230C.The value will vary a little due to different color and printer temperature sensor. 3. Why the filament can not stick on heated bed?In fact when different materials combine together, the adhesion should not as good as the same material itself.So when combining with two different materials, the material character is important.Normally Kapton tape, 3MM blue tape, breadboard are the idea material that can adhere filament.There are also some tips on that:The higher the heatbed temperature its, the better adhesion it is.The distance of nozzle and heatbed more closer, the better quality it is.But need to assure that filament can be extruded within these distance.4. Why the printing failure accurs when using filament?To avoid these issue, you need to confirm:Diameter is ok, no clog on the filament.The first layer should be OK.It is very important for a successful printing.If you solve the above issue and still not get good quality, it should be caused by the printer.Because the precision of printer is very important.The printing work is based on layer by layer when you print something.If the mechanic is not good, the nozzle can touch the printing parts.As a result the nozzle will adhere more and more filament because of hot head can adhere plastic.Then it should cause a failure printing parts.Shipping:UK 1-3 Days Express DeliveryEurope: 3-8 Days Express DeliveryPayment:Paypal Only |
