To mark the 60th Anniversary of the launch of Sputnik 1, I created this model to hang up at our local hackspace. It's not overly accurate, based on photos only, and simplified for 3D prints.
https://en.wikipedia.org/wiki/Sputnik_1
Simply print the 2 body parts and 4 of the antennas and glue together. The antenna are fiddly, but that was part of the design challenge.
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Simply glue the pieces together with suitable adhesive for the plastic/resin you are using.
