This is a 1:200 model of a Tiger II. This model has a snap in turret; after clean up just SLOWLY snap the turret in, no fitting is required. This includes both the Henschel and Porsche turrets.
This is based on m_bergman's excellent model of a Tiger II. The snap joint was derived from the clone trooper model.
Designed to print on the M3D Pro, but it should print fine on the micro.
Printer:
M3d Pro
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
200
Notes:
For a better looking model, print as shown. If you want a quick clean up of the turret, print it with the barrel pointing up. Make sure supports are only set from the print bed to the model. Model on model support and printing the hull perpendicular to the print bed may mess up the snap in joint. Be sure to clean out between the snaps on the turret. This model works well with ABSr grey.
It looks better at 50 micron steps.
