by Geoffro, published
My other Robocop bust always bothered me, the lips were too low in the helmet, and didn't look right and I also wanted to print the OCP logo with it, so this is a new version, higher res (but decimated) and split into 3 if you want to go bigger.
A note on the lenses, I suggest printing with 2 or 3 perimeters/shells, I need to thicken up the lens, but it prints fine (it's thin for a reason.. there is another bust coming soon, similar to my darth vader bust...)
This version has completely new head inside, the lips are more pursed like Peter Weller's, and if you print at 0.15 the font will come out fine on the side of the helmet.
I printed mine in 3 Pieces without supports on any of the pieces, but if you don't have cooling or are printing in ABS, I suggest using supports on the chin section.
Test Printed @ 0.15mm on a Kossel Mini, all up 4 hours at 80ms feed/250ms travel, printed in white PLA,sanded and primed with matte black - ready for paint.
This model and printed replicas are strictly not for sale or profit.
Printer: Omni Consumer Products PR-03
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.15
Infill: 10%
