Table stand Arabian horse I sculpted in ZBrush. Due to its size, I split the horse and made a key/pin to connect both pieces including glue, which also substantially saved materials on support.
I printed the horse with wood filament, sanded it and coated it with Minwax satin. I also fine sanded the hair to highlight it after the paint was dry.
Printer:
Creality CR-10
Rafts:
Yes
Supports:
Yes
Resolution:
0.24
Infill:
10
Notes:
With its original size, each part took about 10-11 hours to print. So, better to print each part separately.
Wood filament may crack more than any other filament, so handle with utmost care during sanding and painting.
To weld both parts, I used Ritocco 3D pen before sanding and painting it.
