Introducing Alba the Alpaca! This is the first time I design an animal that isn't based on primitive shapes. I'm going to move away from primitive shapes for now, especially if i'm going to design anything organic. I won't try to add too much detail though, as too much detail is bad for 3d printing.
Though the last animal I did was an Alpaca I thought it would be best to start from where I last left off.
This mesh hasn't been simplified so I might make a version later that doesn't take as much data.
I haven't printed this with supports but i'm sure that it's possible.
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2mm
Infill:
10%
