by muzz64, publishedMar 17, 2016                       

Summary

'Lucky' Clover Key Fobs are a small fun print for people of Irish descent or who believe that 4 leaf clovers bring good luck. and, if the luck of the Irish is with you they will spin!

There is a 3 and 4 leaf version. They are a quick and easy print without raft or support... and in green of course.

There is a small piece of designed in support that should be removed (but isn't essential). Refer to he instructions and images for additional information.

Note: If you like this check out the rest of my fun and practical designs.

Print Settings

Printer Brand: MakerBot

Printer: MakerBot Replicator 2

Rafts: No

Supports: No

Resolution: 0.20mm / Standard

Infill: 2 Shells / 75% infill

Notes:

Recommend not using Raft so the clover surface is smoother on the bottom. Take care when removing t from your build plate.  No support required.  Use high infill to ensure it is strong and will last well on your key ring.

Post-Printing

Remove the designed in support collar (Refer images)

There is a small designed in support collar on the end that attaches to the key ring. This can be left on however there is a ring around this area to make it cut / break away easily so it works better around  a key ring. It should cut / break away fairly easily.

If your clover fob doesn't spin straight off the build plate a small amount of downward pressure on the clover should free it (Refer images)