This is a self modeled fun remake of a popular gun in destiny 2. I made this for Halloween, comic con, impressing friends exc. It's pre-cut into printable sizes and requires one hollow clear PVC rod inserted into the gap in the top to be complete. I also left the middle section open with hollow tubes running through the print to allow electronics to be added to personalize the print. Some Parts will require being printed on the side, upside down, or however your printer would best handle it, or how you prefer it to be finished.
Printer:
GEETech i3 Acrylic
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
High
Infill:
15
Notes:
Assembly required, its pre cut into the sections that I would recommend for printing. those sections can be inserted into their slots and glued for permanent hold.
For fun design You could always spray paint or add aluminum casing to make the gun look more realistic. I also allowed room in the bottom of the battery on the gun for a real battery that could house electronics and a mother board for a more realistic light up effect. the tubing even stretches up to the main rod where a clear pvc pipe could be inserted with lighting.
With a ton of time, and more patience than necessary
