by tackoum, published
This thing is a pretty big. It was designed to actually hold 2 pens in every honeycomb so if you print the file as it is you will get a pen holder with height: 16cm, width: 24cm and depth: 170cm that can hold up to 24 pens/pencils.
So unless anyone interested has a lot of pencils (and a lot of room on you desk) I would suggest you print this at about 65%-60% size, as i have done in the photos of the printed object. This will give you a more normal sized holder that can easily hold 12-15 pens/pencils.
This was printed with:
Printer: Printrbot Simple Metal
Material: PLA/PHA
Filament: Colorfabb Intense Green
Temp: First Layer-200C / Rest-195C
Layer height: 0.2mm
Speed: Variable - around 45-50mm/sec
Shells: 3
Layers: Top/Bottom - 3
Infill: 20 (but you can always put some more in there for weight)
Supports: No
Time: aprox. 11hours
It might need a little bit of sanding for the tips at the top, if you want a better finished look.
