Life sized maui's hook. Keep in mind this was printed on a large scale printer, so even though it is cut into multiple pieces it will not fit on a regular printer as is. You will either need to scale down everything or cut it into more pieces.
Printer Brand:
MakerBot
Printer:
Rafts:
No
Supports:
No
Resolution:
.3
Infill:
20
This will require a good amount of epoxy and dowels. I started off by putting in dowel holes but found it easier in the end to melt steel dowels directly into the mating surfaces and seal up with epoxy. A 3d pen was used to fill the seams.
