Time to step up your costume game, one claw at a time! I designed these to be functional, dextrous, well-fitting and COOL.
In order to make your own set, there are a few steps!
PLEASE READ!!!
Instructions;
Begin with the "sizer" model. Scale it up by percentage- 150% should be a good start. It needs to fit your fingertip knuckle snugly, but not too tight! NOTE: you probably won't need to go over 200% scale. Mine where: Thumb- 190%, Index & middle 150%, ring 140%, pinky 125%.
Once you have figured out your finger sizes, you can print your claws in the same ratio. The thumb model scales in the same way the regular fingers do.
After they are printed, slip some elastic band through the slots and glue in place on either side.
Done! Ta-daa! now you can paint them and look totally cool!
Please enjoy!!
Printer:
Monoprice Mini Delta
Rafts:
Yes
Supports:
Yes
Resolution:
.2 (can go lower if desired)
Infill:
30
Notes:
I printed mine with a 1.2 shell.
