This is a WIP of Rose's distinctive dagger from Tales of Zestiria, split into a hilt / blade (three pieces of blade, split such that the two pieces with the jagged edge can be printed upside down).
The inside of the blade and hilt has a hole for a 1/8 inch rod to hold it all together and for easier assembly.
I'll post photos of a finished version once I'm done priming/painting.
Printer Brand:
Wanhao
Printer:
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
40%
Notes:
I highly recommend printing the pieces of the blade vertically; make sure you print them in an orientation that makes sense (e.g. so the sharp bits on the sides point up, rather than down, they can't print pointing down!).
