hairetta i wanted a female as they are more docile and less psychotic and live a lot loner than a male
went through 2 roles of error prints to make this
i had to repair a lot to make this thing printer friendly
this was a wonderful model but i had nothing but problems printing with warped parts not sticking to the bed and not printing the hairs because it looks like most are not even connected to the support and the legs are too loose to hold her up on her own and tons of errors in the stll files that xyzware could not fix or repair for proper printing
also i have split the files so there are less chances of printer problems and there are also parts that do not have hairs some tarantulas do not have all that hair
and i did not want to have to set exact printing parameters for each part because xyzware does not allow any of the settings mentioned in the description so these are remade for the standard simple settings of xyzware with no supports
to print the hairs print all the parts with the top door open on the xyz printer other printers have no in closer so this is not necessary for other printers
i have added back the round parts of the legs they had ben cut flat on each side to allow for them to be put together so they are extremely tight to fit a lot of light pressure is required to snap them together one not to keep them from splitting when putting together all parts should be just dipped in acetone if using abs and the cups should be lightly filed so that both flat surfaces are flat and even and the round part should take a file and just a light filing to remove the widest part of the round about 3-4 passes no more
there are still loos parts like legs to the body to tighten all the loose fittings put a drop of paint into the joint you might have to do this a few times to take the gap out like on the but joint lots of play lots of paint drops
