This is not meant to be a diagnostic test for your printer. This is a remix of 3D Benchy with a Pirate ship theme. It was a difficult print as supports are crucial in this orientation and because my settings where a little off, supports where difficult to remove from the backs of the sails. Sails printed in this orientation to strengthen mast poles.Good luck to you.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
10%
The print will require some hands on after printing. Removal of supports from behind the sails was difficult due to my setting, maybe you will do better.. I printed the sails in this orientation to strengthen the masts. Mast holes might need a needle file as mine were a little tight. Good luck!
Tinkercad
