Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the lower level. If you see water there, you have watered too much. The bottom vents allow the soil to breathe.
This was printed using 3D Mars Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.
3D Mars Wood PLA and Bizard 3D Tech Wood PLA: https://amzn.to/2IwVWSr
My Printer: http://amzn.to/2BBYP4t
Printer:
Maker Select
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Notes:
Used 3D Mars Wood PLA and stained it with Min Wax followed by a satin clear coat.
