by WillPio, published
-UPDATE- 26th April
The place where the blade goes needs to be a bit wider. The top support could also use widening. I will update this in the next few days.
Here is the first model I have ever made. This may have errors. I have not yet tested it.
200 mm tall and 100 mm wide
Printer: Da Vinci 1.0A
Rafts: No
Supports: Yes
Resolution: 0.3
Infill: 20-25%
Notes:
This needs a very small amount of support. Also infill could be lower than 20%. 10% and up should be good, no need for more than 25%
