by MakotoKamui, published
A replica of the Night Night Gun, later converted to ICER, from Agents of SHIELD. Model was created in 123D Design, and will probably need to be sliced for printing, along with a mirror print of each for both halves of the gun.
The insides are hollowed out in a few places, though you don't need to remove support material if you don't want, it was mostly to cut back a bit on the plastic used.
Printer Brand: Robo 3D
Printer: R1 ABS + PLA Model
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: .1mm
Infill: 10%
I traced the screenshot in Inkscape, then brought it in to 123D Design to extrude, round, and combine
