by bitbashing, published
Enhanced hooking action!
This is replacement for the lightswitch by my door so I have a place to put my keys and headphones.
Probably not UL approved...
Its also pretty bland ascetically, I might come back and do a hex pattern or something after living with it for a bit.
Printer Brand: LulzBot
Printer: Mini
Rafts: No
Supports: Yes
Infill: 20%
Notes:
I used the defaults in Cura with a generic profile for medium quality ABS with supports from the bed only. I also disabled "solid infill bottom" to save a little time. You should print this with the back of the lightswitch against your build platform. The front curve is at the limit of my printer's ability to do a decent job with so you may need to also play with the CAD a bit.
