Quick note: I'm the original creator of this model. It was first exclusively posted on MyMiniFactory by me, but quickly reposted here on Thingiverse without permission, and the person in question refused to remove it when requested to.
Or in this case: plastic.
This guy is a huge part of my childhood. I hope I did him justice here, and that you, dear visitor, have a good time printing him (should you choose to do so) and give him a good home on one of your shelves!
Preferably far away from any rocks printed in transparent, green, filament.
Sculpted in ZBrush. Printed on a CR-10S.
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.12mm
Infill:
5 or 7%
Notes:
Printed on a CR-10S at 0.12mm layer height, 190°C, 60 mm/s, 5% (or maybe 7%...) infill, using a 0.4mm nozzle.
The lower "wedge" part needed some custom supports in Simplify3D.
