This is The Trapper's Cleaver from the popular video game "Dead By Daylight".
I found this as a game rip file from somewhere (not sure where) a long time ago and decided I would like to print it so I scaled it to size and sliced it up.
NOTE:
I will be using ABS to print this with so I can use an ABS slurry to bond it and make it stronger because of the beatings it will endure during cosplay.
I dont reccomend PLA unless its just going to sit there.
Also, i would print as vertically as you can to avoid using supports as much.
other than that, GOODLUCK!
Printer:
Anet A8
Rafts:
Yes
Supports:
Doesn't Matter
Resolution:
.3
Infill:
30% Recommended
