by simpai
This is a Smurf house.
Except roof, you can print them without support.
MainBody and Window has designed support which should be removed after print.
I tried to separate colors. And it makes it little bit difficult to assemble.
This will help you to figure out how to assemble them : a360.co/2JvHsr7
I printed them with 0.2 ~ 0.24 layer height.
with 10~30% infill and 2 walls.
Printer:
Voron 1.55
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2~0.24
Infill:
10~30%
Notes:
Supports are only needed for Roof.
"Window" and "MainBody" has designed supports. So you should remove them carefully before assembly. And some parts may need additional processing like sanding to fit. (sorry about that)