by SubjectGamma

This is my interpretation of the pods from NieR: Automata. I've designed the model to be both very screen accurate and structural. My end goal is to make a drone using this model, once I have the actual drone parts in hand I will also upload pieces for conversion from a static model. The headplates are made to be held on with small magnets readily available from amazon. There are screw holes that run through the bottom of the shoulder into the neck and upper arm pieces, as well as from the elbow into the upper arm. There is a continuous channel running out the back of the abdomen, into the neck, and into the head to run wires for speakers. The pegs and holes are likely tight and may require some additional sanding. I'd be happy to answer any questions surrounding the project!

Print Settings

Printer Brand:                      

FlashForge

Printer:                      

Finder

Rafts:                      

Yes

Supports:                      

Yes

Infill:                      

5%

Notes:

The Headplates do not require a raft and should have infill set to 0%. The scaling for my print at estimated life size was 1080%, the head height is approximately 11" when printed.