by Rogierrzz
Piece to hang your bag on. This way it can fit on the clothes rack. If you print it with the recommended settings listed below it is strong enough to hold a 10 pound bag.
On the photo the back hanger is version one, the hanger with the bag on it is version two.
Thingiverse turns the model up side down. You need to rotate it so it lays flat on it's back. Then it will print like a dream.
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Notes:
Walls: 6. This is to make the part way stronger. printed it in PLA. ABS would even be stronger, but i don't think there is a need to use ABS.
Designing
Used Fusion 360 to design the hanger.
