This is the first object I designed from scratch in blender. pretty basic, but makes a nice flower pot! somehow a couple of vertices got tweaked, so it has a very slight lump on one side, but I left it in because it gives it character. I really only noticed it because the simplify3d was doing some weird paths around that area, and also i printed in translucent filament which made it super obvious. anyways, it's fine. enjoy!
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
.2 mm
Infill:
20%
Notes:
supports only needed for the handle. I set min angle for supports to 65 degrees.
