by NickJCSQ
This is an acrylic palette designed for "on-table" use. It has a couple of holes for you to hold it if you prefer to, but its intended purpouse is for it to be still, desgined to colour 3d prints.
The center circle is intended to support the 3d print you want to paint. On the right side you have different circles for you to put and or mix paint, with different sizes based on the amount you would like to use. It also has a hole for a glass of water to clean your burshes (a 3d model for a cup is also attached in this page).
On the left side there are different holes for your brushes, each one with a different diameter.
Moreover, there also is the previously mentioned hole used to hold the palette, in case you prefer to do so.
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Infill:
10%-15%
Notes:
Be careful with plate adhesion. Since it is a pretty big and flat print it is highly probable for it to bend or not stick properly to the print bed. I recommend using a lot of hair spray or a glue stick, since it needs more help than the average print (at least in my case).
