by hellra1ser
Attention: I have not tried printing the molds yet!
Nor have I tried if the cast parts will fit in the assembly. I think there will be a little sanding required.
This is a remix of the work done by lonewolf011 - I dont wanna print the discs.
Instead i'll made it of plaster or clay.
This remix provides respective molds, sized to 70% of the original size to be printed on a 215x215 printbed (providing space for 10mm brim).
The molds are designed that the parts can be removed without destroying the mold hopefully (untested design ;)
Printer:
Extremely pimped RRP Mendel
Rafts:
Doesn't Matter
Supports:
No
Resolution:
Adaptive
Infill:
10%
Notes:
I'm trying the cura experimental feature for adaptive layer height to reduce print time by retaining the details in the mold.
Resulting layer heights: 0.15 - 0.35mm
