My Dragonborn Paladin - Arjhan Nemmonis
Been using a Heroforge mini for 2-3 years but it snapped on me (Had another snap on me too about the same time). It was time to make my own model.
Needed someone in full plate and "The Sorcerer" looked amazing.
Replaced his head with the head from "Son of Frost Dragonborn."
Reposed his left arm so sword goes to the ground. Lengthened sword to get it to the ground. Fixed fingers so armor is solid (gaps in knuckles)
Removed spell effect from right hand, rebuilt fingers, lengthened arm so both arm lengths match (this was a weird one a friend pointed out and once seen it couldn't be unseen).
Reposed right arm forward and hand left empty in case you want to put something in it.
Angled stance upright and needed riser to ensure feet are on solid ground.
Cut head off of "Son of Frost Dragonborn"
Cut tail off of "Torinn - Dragonborn Fighter"
Cut into three sections so could pose it more up the back and tilt it down
Added special support strut to ensure good printing. Without it had problems every time with test prints of the tail.
He's a big character (6'8'') and my scale for mini's is ~36 for normal height so he's at almost 40mm total height.
Thanks for all of the original designers to give me the things I needed to put this character together.
Printer Brand:
Wanhao
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.06 with 0.3mm nozzle
Infill:
30%
Filament: eSun PLA PRO Orange
Notes:
Cura Tree Supports. Cut off tail support if it doesn't come off when cleaning.
