by Jeremycon

Hi Folks
been thinking about doing one of these for quite a while, and here it is.
Fully wearable, the current size is about 200mm helmet bowl diameter so scale to suit.
It is quite a long print with each part taking about 1 ,1/2 hours at 0.25
orient the parts for best printing, I found the peak to be best printed on its two ends, supports are needed on most, but they are quite small supports.
Some of the parts are obvious like 'Front plate x3.stl' print 3 off, otherwise print x1
you will need to glue the parts together but they do have location tabs to help.
there are some different parts so choose the ones you like
Next job is to paint it
Enjoy and if you print please post pics
Thanks for looking

Print Settings

Printer Brand:                          

Up

Printer:                          

Up Plus2

Rafts:                          

Yes

Supports:                          

Yes

Resolution:                          

.25

Infill:                          

20%

Filament:                                            Tiertyme ABS                                                                                

Notes:

used various reels for this as was printing other things at same time, some supports needed but they are small, assemble with glue.