This is the amazing Halloween Pumpkin Spider Transformer created by Megawillbot, but changed to my principle "The best support is the one you don't need".
Therefore I cut it in a way so you can print it easy nearly without supports! Use CA glue to join the splitted parts.
Note that the Chest_lower still needs support, but it will be easy to remove and the surface isn't visible in the final product.
Additional, I separated parts that need different colors, so you can get a nice result without painting it.
I also fixed an error in the Chest file, where there was a small gap between the sphere and it's post. Without that fix you might get a sparse layer just below the sphere which will likely break later.
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.15mm is fine
Infill:
10-20%
