Here's a wee little axe I made as a prop for my son's Halloween costume! I split the head for easier printing but there is a solid model for those that prefer it. I had to file the inside of the axe head to get it to pop on so you may have to do the same.
Hoping to get a little chainsaw made by the end of the week too!... STAY TUNED
Happy printing and Happy Halloween!!!
Printer Brand:
Prusa
Printer:
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
10% Head 15% Handle Gyriod
Filament: i-Print3D ABS Brown, Grey
Notes:
If printing in ABS try to use a 5mm brim for better adhesion and help against warping.
Supports will most likely only be needed for the solid axe head, and to be on the safe side I also did supports the lower part of the handle.
