by vandragon_de
Now that the cold season is slowly beginning again, it is very helpful to have an icebreaker in your fleet. Even if few of you will bathe in the bathtub at these temperatures, you can at least use ICE to push the foam away. Let your imagination run wild.
Have fun printing :)
Instagram: https://www.instagram.com/vandragon_de
Although it is a lot of fun to draw boats and bring them to life, it takes a lot of time to research and draw. Especially the 1:1000 scale models are very time-consuming. So I wanted to see if there are any dear enthusiasts among you who appreciate my work and support me a little bit. Thank you for your help :)
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
50% / 10%
Notes:
The infill must be printed obliquely
example
The lower section has 40% infill, the upper 10%. For this purpose I have extended the surface layer to 6.
Multicolour was made possible by changing the filaments. As always with my Prusa and Slic3r, an M600 command was simply inserted in the appropriate places.
Ship:
Blue layer 0 - 7.0mm (Layer 0-35)
White layer 7.0 - 8.0mm (Layer 35-40)
Black layer 8.0 - 27.60mm (Layer 40-138)
White layer 27.60- 89mm (Layer 138-445)
Funnel:
Black layer 0 - 7.40mm (Layer 0-37)
Blue layer 7.40 - 8.40mm (Layer 37-42)
Red layer 8.40 - 16.40mm (Layer 42-82)
Blue layer 16.40- 17.40mm (Layer 72-87)
Black layer 17.40 - 22.20mm (Layer 87-111)