A tree house.
I hope you'd like it.
Model on photos' 20cm height, however original file's 9cm only.
As you can see it's work in progress file, so there may be some updates soon. I was thinking about some more details, lines and outside house items (chair, balcony, chest etc).
Drop me a comment if there's anything you think may be good addition.
Your feedback would be much appreciated.
See notes about printing
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
No
Supports:
Yes
Resolution:
0.1 - 0.2mm
Infill:
15-25%
Filament: unbranded PLA grey
Notes:
Overal printing resolution was 0.1mm, but to speed it up base was printed at 0.2mm.
It came out not too bad, however material I used wasn't very good so there're some visible underextrusions in the model.
Supports are a bit tricky. I made few mistakes and placed them behind ladder. It broke while removing supports, well we all learning.
