by FablabMoebius, published
This is a nice, clean, minimal spool stand. It requires no hex nuts, no screws nothing except 4 standard 608 bearings !!
See build instructions.
To build your spool stand print :
2x spool-stand-side.stl
if you use standard spool, print 2x spool-stand-standard.stl
if you use Printrbot plywood spool, print 2x *spool-stand-printrbot.stl**
print parameters : 2 external perimeters + 35% infill
Get 4x 608 bearings and clip them on the spool-stand-side axes.
Clip spool-stand-standard or spool-stand-printrbot on the spool stand sides and you're done !
Caution : depending on your printer's precision, you may need to sandpaper axes and parts ends a little bit.
