by VJM787

This is a 1:76 model of the Land Rover Wolf 110, general purpose use.  It is based on the SketchUp library skin model provided by Austin T. (my thanks), and has been developed using SketchUp and 3D Builder (my thanks to AutoCAD and Microsoft), iteratively.
The model required quite a lot of modification and strengthening, so the chassis and body reflect these changes.  The crew framework is not fully satisfactory, despite strengthening (further thought required).  I have provided versions with solid windows (perhaps a bit too thin), without windows, and broken into components.
This variant uses the extended air inlet pipe - it could be added to the earlier Wolf 90 model if required.
Dimensions were checked with MiniMagic, which is proving useful, and should be about right.
I had problems with the wheel arch extensions - hopefully now fixed, but a bit of a bodge!  Will review as the opportunity arises.  The bonnet prints with steps, unfortunately, but I am not sure if this can be improved. The wheel is from the Wolf 90, as it should be the same, but I need to check the mounting hole dimensions, as the chassis required strengthening.
I hope this model is of interest - enjoy!

Revised main body, as had not corrected the back right wheel arch extensions...  Apologies!