Summary

This is a 3d-printable model of an old Dutch "Delfts blauw" tulip vase. I wanted to buy one but they were too expensive so i made one myself! I split it in two parts so it should fit on most printers ( i own a Wanhao i3).

Make sure you make it watertight after printing. Mine was slowly "sweating" water over time.

Print Settings

Printer: Wanhao duplicator i3

Rafts: No

Supports: No

Resolution: .2

Infill: 20

Notes:

I use 20 percent infill to save time, but mine wasnt completely watertight, maybe using 100 percent infill is better. Make sure to rotate them so theyre the right side up. Solid Works and Cura disagree about wich way is up.