by kendel3d
These are simple spinning tops. Printed solid in PLA. The model is optimized for 0.4mm nozzle.
Printer:
Rafts:
No
Supports:
No
Resolution:
0.4mm nozzle, 0.2mm layer height
Infill:
100%
Filament: Atomic Filament PLA Yellow
Notes:
Top 2 is a little more aerodynamic so it spins a little longer than top 1. To keep the top of the top from looking like a melted blob, you can either print more than one at a time or when slicing you can set a minimum layer time of 7-10 seconds. Print them solid so that you have enough weight for the gyroscopic effect (angular momentum) to work.
Your might need to ream the bottom of the top opening so that the point fits in. Don't over do it though, you want a nice tight fit.
