by SavageRodent
This is a remix of standing rabbit by bs3.
The idea was to turned it into a Christmas tree decoration... well it doesn't have to be for Christmas I suppose!
I have slightly changed the look of the original and turned it into a screw-shut container, so it can hold treats, I've also given it a ring so that it can be hung from a Christmas tree.
I used bs3's rabbit model because it is nice and minimalist, so there aren't to many constraints on how you choose to decorate it.
As you can see I've only got as far as giving it a coat of primer myself :)
.
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
20
Filament: Rigid Ink PLA
Notes:
I did use supports on the bottom half.
I would advise against using supports on the top half as they might clog up the screw. You will probably want to clean up the underside of the ears after printing but i didn't find the overhang of the ears to be to much of a problem, even without the supports.
