by MFWIC3D
Remixed the ABR-3
Split Shell into 2 pieces, so they fit on a CR10S vertically or horizontally, screws together rather than glue joints, barrel section provides cantilevered support to split.
Reworked the barrel assembly so it used about 60% less plastic. Will require a 3/4" PVC barrel.
Replaced the original flywheel cage with a OFP stryfe derived cage. Rotated the guide to suit the horizontal orientation. Should allow a Ultrastryfe cage to fit as well. Increased the width of the flywheel housing to accommodate, added some fillets to round it out more make it match the rest of the P90 body.
Have not test printed, do so at your own risk, should be printing around xmas day.
Update 12/16/2018
Found glitch in the matrix, reworked front shell a bit - rounded barrel support at front was omitted from original export due to PEBKAC error.
