by Glistco
We are providing the files for the stand that we sell. The base is quite large and you will want to print the first few layers slowly. The stand is made specifically to hold the oculus touch controllers and headset.
I would recommend printing the center piece in ABS as PLA may crack while putting in screws. Everything else should be fine in PLA.
The ridge piece prints best with support on the lip portion. Also adding a skin (cura) to the top will help with a clean removal.
These screws will fit perfectly with this design. You will need 7 of them.
https://www.mcmaster.com/#90380a145/
Printer:
Creality Cr-10
Rafts:
No
Resolution:
.3mm
Infill:
20
Filament: Any PLA/ABS Any