There were a few things I didn't like about the original pipe revolver, so I fixed them and uploaded it. Here are the changes I made:
-Increased bullet length to fit the cylinder
-Created an empty bullet shell
-Created a lengthened, ported barrel (I felt like the barrel was short for the overall length of the revolver)
-Created cylinder stops so that when you swing out the cylinder to reload, it doesn't just flop everywhere
-Created shell stops to prevent the bullets from falling out of the cylinder when it is closed.
Printer Brand:
Creality
Printer:
CR-10 Mini
Rafts:
Doesn't Matter
Supports:
No
