by rondocbondoc
Yeti! Sitting at a little bit short of 55mm with the base.
Sculpted in Zbrush, rendered in Keyshot, printed on an Anycubic Photon printer using Monocure3D Rapid Grey.
Feel free to share any images of your print, but please credit myself, rondoc bondoc, for the model. Tips are not necessary, but always welcome! Enjoy!
Printer Brand:
Anycubic
Printer:
Photon
Supports:
Yes
Notes:
This particular print with Monocure3D Rapid Grey was printed with the folowing settings:
Layer Thickness: .05
Normal Exposure Time: 12
Off time: 1
Bottom Exposure Time: 90
Bottom Layers: 12
Printed at a 45 degree angle using medium strength supports/
