by SilverSkullJS, published
This is a life-sized (based on my hand measurements) recreation of the Halo Series' Energy Sword.
Supports: Yes
Resolution: Depends On Your Preference For The Slant Sharpness
Infill: %20 - %50
Notes:
The 3 parts: the handle (print 2 times), the blade hilt (print 4 times), and the blade tip (print 4 times). Adjust the Infill to suit your needs: The Lower The % The Lighter It Is, but It Will Be Not as Strong (Use for a display or model to put on a shelf) The Higher The % The Heavier It Is, but It Will Be Stronger (Use for sword fighting, rough shipping, etc.)
Post Printing
These parts will need to be slotted together and glued. The slots may turn out slightly out of measurement, so some filing/cutting may be required, these are here only to help the final creation stay together. The handle pieces are placed one on another, the hilt pieces one on another for both sides, and the blade tip one on another for both sides. I strongly recommend piecing together one half then the other then gluing each half together.
