by BulldogUK
Another remix of the AT-TE. I suddenly realised that the AT-AP was just bits of the TE repurposed so off to Tinkercad I trotted! As with my other models I took this to a level where post print detail would be added (that's what I enjoy). If you check out the pics all the pre-paint white detail are added plastic card. feel free to remix with pre print detail if that's not your poison!
simply mirror the left leg parts to create the right leg. tbh I am not sure wether I did and it turned out OK so experiment in your slicer of choice, it may not be necassary!
have fun :)
Printer:
Balco
Rafts:
No
Supports:
Yes
Resolution:
0.25 adaptive
Infill:
15
couple of blasts of filler primer, fine surface filler, sand and repeat!
