by SeaDaddy
This is an "unseen" Battletech Locust LCT-1M based on the Ostall from Crusher Joe.
I built 3 versions of this model in Tinkercad during my Saturday stream of "MECH SCHOOL" on Twitch.tv/theseadaddy.
The file prints well at its current size although some may find it a bit big for the table top. I have printed at 90% but do not recommend going any smaller than that. I have included a picture of a 100% print next to an old Hunchback mini for size comparison.
The weapons pods are delicate, to say the least, and you will need to be careful if you decide to transport them.
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
Yes
Supports:
Yes
Resolution:
.025mm
Infill:
Yes
Delicate at best
Post printing I removed the supports and the results were not too bad.
