by Dwnldz
Not much to say about this one. I've modeled it after Red Alert 2's Tesla Reactor, and its partly hollow inside so you can do whatever you want with the space (or not).
I had to make some minor tweaks to make it printable, but those are hardly noticeable.
Indicators after the file name:
_x2 = print it twice
_X4 = print it four times
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
10 %
Filament: HobbyKing PLA
Notes:
You will need to set supports, and most likely to scale the model down as it currently requires something like 400x400 mm bed. I've printed my model at 40% size (look at the photo). Remember to scale every part by same amount to ensure they fit together for assembly.
I suggest three perimeters to get good overhangs, and layer height of 0.2 works well. For the sphere I'ld go with 0.1.
