by VJM787
This is a 1:76 model of the post-war Russian airborne 57mm SPG. It has proved challenging to print, and is not ideal at present, as the tracks do not print particularly well, and the model is not easy to split into different parts if separate printing is preferred.
The model was based on a skin model found in the SketchUp library (published by Andrei M., to whom my thanks), but required almost complete re-skinning to get round zero-thickness issues. I suspect that the remaining challenges with splitting the model arise from this work not being complete. Tracks were thickened up and redone to try to get better printing, but it could do with further improvement. Most of the work was done in 3D Builder.
It makes for a nice, small model, but may not scale well to smaller scales, but should be fine to enlarge. Any feedback would be welcome, as I am learning the limitations of this printing technology.
Enjoy!
