by Jeremycon
Hi Folks
here is my little design for a British Morris CS9 Armored car from WW2 scaled to 1/100
to enlarge to 1/72 multiply by 1.4 approx.
Print everything horizontal.
The guns will be small good luck printing them, or add your own, these were printed at .15 layer on an Up Plus 2 and actually worked.
I did break of the support for the Bren gun on the back of the turret (dropped the turret) DOH!
Thanks for looking.
Printer Brand:
Up
Printer:
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.15
Infill:
20%
Filament: Tiertyme ABS White
Notes:
Supports needed, but are minimal, i suggest if you are going to print the guns 'high infill required'
