by 3dmpro
Jiminy Cricket is based on the character from the story of Pinocchio. This version was inspired by the 1940 feature film. The full character is available at CGTrader (http://www.cgtrader.com/3dmpro), as are many other print ready characters, for free or at low prices.
Jiminy requires support for his chin and the rear edge of his hat. Other than that, the rest should print without incident.
Printer:
Zonestar Z5M2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.1 to 0.3mm
Infill:
0 to 100%
Filament: Any Any Any
Notes:
Make sure that your slicer is set to union or combine overlapping geometry, as some areas contain overlapping geometry.
